Extra Wide Peel & Stick DIY Self Adhesive Wallpaper - Grey Stones
Rejuvenate your interior walls, backsplash, bathrooms, closets and other flat surfaces. Super easy to install DIY. Perfect for living room, kitchen, bedrooms, office, laundry room, RVs or college dorm.
Glue: Self Adhesive (removable)
Life: 3 to 5 years
Features: Oil Proof, Water Proof, Easy to Remove.
Installation Videos: (Source: YouTube)
- Sponge to clean the wall
- Tape Measure
- Steel Ruler or Straight Edge
- Razor Knife
- Plastic Squeegee
Step 1: Prepare the wall: Remove electric switch covers and other wall fixtures. Use wet sponge to wipe off the dust from the walls. Fill the voids, if any. Make sure that the wall is smooth, dust free and dry.
Step 2: Starting from the left side of wall, measure out from the corner the width of the paper and mark the wall lightly with a pencil. Put your level on this mark and draw a straight, level, vertical line. This is the guide for your first strip, it is very important for it to be level. Remember to allow an extra inch or two for trimming both the top and bottom.
Step 3: Pre-cut strips to fit wall height and make sure to align the design from strip to strip when cutting. Cut and trim product with a sharp razor knife
Step 4: Peel off about 12 inches of the backing paper away. Position the paper to the top of the wall and stick it allowing a bit of excess to overlap the ceiling (to be trimmed off later). Align the right side of the strip to your mark and lightly press the edge to the wall along the mark. Working from top to bottom, pull the backing away as you evenly press the paper to the wall. Be careful not to pull or stretch the material or the pattern will not align.
Step 5: Using the plastic squeegee, work your way down the strip in a back and forth motion, smoothing the material to the wall and pushing out any air bubbles. Trim off excess material at ceiling and baseboard with a straight edge and sharp razor knife.
Step 6: Repeat above steps to cover full wall